How To Repair Cracked Cabinet Door

A chiffonier door can sustain damage ranging from a few shallow scratches to a deep crevice in its surface. Accidents happen; the chiffonier can hitting confronting the door frame, or pocket-sized children can end upwards swinging from information technology when you lot're not looking. Fortunately, you tin can set cracks in wooden cabinet doors finer past following the steps beneath.

Step ane - Decide the Depth and Total Length of the Crack

Examine the door closely to get a good look at the full extent of the cleft in the forest, and how visible it will exist in one case repaired. Likewise bank check how far information technology is from the edge, top, or bottom of the door and its handle.

Step ii - Clean the Door Surface

Clean the wood surface of the door with soapy hot water and a sponge to remove any grease, dirt, or other debris. Then, rinse the door surface well with hot water to expand the crack slightly. That way, information technology will be easier to fill.

Footstep three - Strip Any Existing Paint or Varnish

While wearing protective gloves, utilize paint stripper to remove any paint or varnish currently on the surface around the damaged area. It's important to be thorough in this example because these finishes adhere and so tightly to the wood that they will prevent the crevice from resealing when filled.

Step 4 - Remove Any Materials Used to Patch the Crack Before

Sponge the fissure with a clean cloth soaked in hot water to loosen and release whatever caulk, putty, epoxy glue, or other materials used to try to patch the crack previously. Allow the scissure to dry for several hours afterward.

Footstep 5 - Sand the Inside of the Crack and the Edges

Using the coarse-grit sandpaper, sand the inside of the crack and the surface edges to create a moderately rough texture to which the epoxy forest paste will be able hold more firmly.

Step 6 - Apply the Wood Epoxy Glue

Make full the fissure in the door with the epoxy woods paste right upwardly to the surface. Spread a pocket-sized bit of the paste over the sanded surface to help close and bond the edges of the crack together besides.

Step vii - Clench the Cleft on Both Sides

Adhere wood clamps across the fissure where yous can to hold the sides as closely together as possible while the wood epoxy glue dries. This will help create a more inconspicuous repair. Drying fourth dimension should be about three to iv hours, but be sure to bank check your epoxy packaging if you are unsure.

Step viii - Refinish

When the crevice is dry out, remove the clamps carefully. Sand all around the repaired area with the fine-grit sandpaper to create a smooth surface. So, refinish as neatly as possible with a varnish or paint that matches the other doors. If the new finish does not look satisfactory, strip and refinish the unabridged door, or take this opportunity to revive all your kitchen chiffonier door fronts past cleaning and refinishing them in a new coat of paint, varnish, or other material.

The near important keys to success in this chore are clean, dry surfaces for patching, careful grooming and filling, and patience to ensure the patch is completely dry before refinishing. Don't effort to rush through this steps, equally you will likely end up with a look you aren't happy with equally a consequence.

Source: https://www.doityourself.com/stry/how-to-repair-a-cracked-wooden-cabinet-door

Share this post